Speaking of centrifugal fan, everyone is familiar with it, and there are many problems when using it. For example, how to prevent the deformation of the main shaft of the centrifugal fan? Let's make a brief introduction to this question.
Centrifugal fan is the equipment used in all major industries. Because of its many advantages, it is favored by users. It is important to know that the extended use of the centrifugal fan causes the deformation of the main shaft. Therefore, the measures to prevent deformation during use are as follows. For the staff, what you need to know here is that when the fan does not stop, it can rotate the propeller of the aerosol fan and properly lengthen the exhaust speed of the tail, so as to increase the negative pressure at the fan inlet at very low temperature. In addition, when using the centrifugal fan, you need to understand that the central operation instruction is determined by standard operation and the technical parameters are strictly limited. At this time, it is mainly used to measure the exhaust volume and pressure regulation at the inlet of C-1 pipe of the Keelung heat exchanger. What you need to know here is that when the exhaust measurement at the inlet of C-1 pipe is less than 430 ° C, the negative gas of centrifugal fan shall be strictly controlled. In this way, the deformation of its main shaft can be prevented. Friends who don't understand this question may as well come here to learn. I will understand when I see it later.
In addition, when using the centrifugal fan, the staff also need to understand that when the live recording at the main station is not activated and can be activated immediately, the auxiliary transmission of the centrifugal fan should be set. And like some relatively low temperature fans, they slide at low temperature to ensure uniform heating of the main optical axis. So what you have to do at this time is
A failure emergency plan is needed, and the main purpose is to ensure the safe use of power failure. Add combustion gas temperature sensor at the inlet of high-temperature fan. Of course, if the inspection door of C1 cylinder needs to be opened after closing when operating the centrifugal fan, the forced cooling should be stopped and the inspection should be carried out at the same time. When using a centrifugal fan, use it according to the method used.